ServicesPaint and Refinishing
Paint and Refinishing in Farmersville
We fix scratches, peeling clear coat and faded panels at our shop, and we match the color to the rest of your car. If buffing or a spot repair will do the job, we tell you. A full panel or full car refinish is only on the table when the paint really needs it.

Fix the paint you have before you replace it
Most paint damage is smaller than it looks. A scratch that only cut the clear coat can often be wet sanded and polished out. A key mark or scrape down to primer needs that spot built back up, but not the whole door. We start with the least work that will last, and we explain why.
Some paint can't be saved that way. When clear coat is peeling in sheets or the color has gone chalky across the hood and roof, sanding one spot just moves the problem. Long summers of strong valley sun do that to a lot of cars. In that case we'll show you where the failure runs and talk about refinishing the affected panels, or the whole car if it's that far gone.
Repair before replace is how we work, on paint the same as on metal. You get a finish that matches and holds up, and you don't pay to repaint parts that were fine.
What our paint work covers
- Scratch and scuff correction
- Light scratches in the clear coat get wet sanded and machine polished. No new paint, no color match to worry about.
- Spot and panel repair
- Deeper chips, key marks and scrapes are sanded, filled if needed, primed and refinished. We keep the repair as small as it can be while still looking right.
- Color matching and blending
- We start from your car's paint code, then spray test cards and check them against your car in daylight. Factory colors shift with age and sun, so we blend the new color into the next panel so you can't see where the repair stops.
- Clear coat replacement
- Where the clear has failed but the color under it is sound, we strip back the loose material and lay down fresh clear. Peeling hoods, roofs and trunk lids are the usual spots.
- Full refinish
- When the paint is failing over most of the car, we refinish it properly. That means removing trim and handles where needed instead of masking over them, so there are no tape lines or overspray on rubber.
- PPG paint systems
- We're PPG certified, and we use their primers, base coats and clears on the paint work we do. That gives us consistent color formulas to match against.
Paint problems worth bringing in
Clear coat lifting at the edges
Hazy white spots that start to curl up mean the top protective layer has failed. Once that starts, it spreads. The color underneath fades quickly without that layer over it.
A scratch your nail snags on
Run a fingernail across the scratch. If it catches, the damage is through the clear coat. Polishing won't take it out, and it should be refinished before water reaches the metal.
Blisters near wheel wells or door bottoms
Small raised bumps in the paint usually point to rust forming underneath. New paint on top of them won't hold. We clean the metal back first, then refinish.
One panel looks a shade off
In bright sun, a fender or door that doesn't quite match is often an old repair done without blending. We can redo it so that side of your car looks like one color again.
Dull, chalky color
Red and dark paint lose their shine first. Compound and polish can sometimes bring it back. When they can't, the paint is worn thin and refinishing is the fix.
What sets the price of paint work
Paint pricing depends mostly on how much area needs work and how deep the damage goes. A buffed-out scratch and a full refinish are very different jobs. We'll give you the numbers in writing before any sanding starts, and we don't add work without talking to you first.
Depth of the damage
Clear coat scratches can often be polished. Damage down to primer or bare metal needs filling, priming and new color, which takes more labor and material.
How many panels
Each panel painted adds prep, paint and time. Blending into a neighboring panel adds some cost too, but it's what makes the color match.
Your color
Solid colors are the easiest to match. Metallics and three-stage pearls take more test sprays and more material to get right.
What's under the paint
Rust, old filler or a past repair that wasn't done right has to be dealt with before new paint goes on. We show you if we find it.
Trim and parts removal
Handles, moldings, emblems and lights come off for a clean edge. Cars with a lot of trim take longer to take apart and put back together.
How a paint job runs at our shop
- 1
Look it over with you
You bring your car in and we go over the damage together in good light. We check how deep each scratch goes and whether the clear is sound around it. Then we tell you what can be repaired and what can't.
- 2
Written estimate
You get the estimate in writing, panel by panel, with any blending listed. If a spot repair and a full panel are both reasonable, we show you both and say which one we'd pick.
- 3
Prep and color match
We remove trim, sand the damaged area and feather the edges so there's no ridge. Primer goes on and gets sanded smooth. While that cures, we spray test cards to dial in the color.
- 4
Paint, clear and cure
Base coat goes on, then clear, in a clean booth. Once it's cured we color sand and polish to match the gloss of the paint around it.
- 5
Final check and pickup
We look at the work outside in daylight before we call you. When you pick up, we walk you around it and tell you how to wash and care for the new paint.

Paint and refinishing questions
Will the new paint match the rest of my car?
That's the goal on every job. We start from the paint code, spray test cards, and compare them to your car in daylight because the original color has aged. Then we blend into the next panel so there's no hard line where old meets new.
Can you paint just one spot instead of the whole panel?
Often, yes. Small chips and scratches near an edge or body line can be spot repaired. A scratch across the middle of a big flat hood is harder to hide, and we'll tell you if a full panel is the better call.
Is it worth repainting an older car?
It depends on how bad the paint is and what you want from the car. If the clear is failing everywhere, refinishing just the worst panels can make sense on a daily driver. We'll lay out the options and you decide.
What paint do you use?
We use PPG paint systems for our paint work. That covers primer, color and clear, so every layer is made to work with the one under it. It also gives us reliable color formulas to start from when we match your car.
How do I take care of the new paint?
Hand wash it for the first while and hold off on waxing until we say the paint has fully cured. We'll go over the details when you pick up your car. Parking in shade when you can helps any paint last.
Will insurance pay for paint damage?
If the damage came from an accident or vandalism, your policy may cover it. Fading and peeling from age usually isn't covered. Our Insurance Claims page explains how we work with your insurer on the estimate.

Find out if your paint can be saved
Give us a call and describe what the paint is doing. Then bring your car by the shop, and we'll go over it with you in good light. You'll get a plain answer on whether a repair will hold or a refinish makes more sense.